3axis CNC Milling Engraving Mashine X:230mm Y:84mm Z:15mm XY: 1500mm/min Z:300mm/min VacuumTable 120mmx200mm VacuumCompressor: 100mbar(-0,9bar) 100%ED

Firmware:GRBL 1.1 Chip: m328p Driver: PololuLolo$random Interface: RaspBerryPi3B running CNCjs

GRBL 1.1 config:

$$ $0=10 (Step pulse time, microseconds) $1=25 (Step idle delay, milliseconds) $2=0 (Step pulse invert, mask) $3=4 (Step direction invert, mask) $4=0 (Invert step enable pin, boolean) $5=0 (Invert limit pins, boolean) $6=0 (Invert probe pin, boolean) $10=1 (Status report options, mask) $11=0.010 (Junction deviation, millimeters) $12=0.002 (Arc tolerance, millimeters) $13=0 (Report in inches, boolean) $20=1 (Soft limits enable, boolean) $21=1 (Hard limits enable, boolean) $22=1 (Homing cycle enable, boolean) $23=1 (Homing direction invert, mask) $24=500.000 (Homing locate feed rate, mm/min) $25=1500.000 (Homing search seek rate, mm/min) $26=250 (Homing switch debounce delay, milliseconds) $27=0.800 (Homing switch pull-off distance, millimeters) $30=1000 (Maximum spindle speed, RPM) $31=0 (Minimum spindle speed, RPM) $32=0 (Laser-mode enable, boolean) $100=629.851 (X-axis travel resolution, step/mm) $101=633.000 (Y-axis travel resolution, step/mm) $102=633.000 (Z-axis travel resolution, step/mm) $110=1500.000 (X-axis maximum rate, mm/min) $111=1500.000 (Y-axis maximum rate, mm/min) $112=1500.000 (Z-axis maximum rate, mm/min) $120=40.000 (X-axis acceleration, mm/sec^2) $121=40.000 (Y-axis acceleration, mm/sec^2) $122=40.000 (Z-axis acceleration, mm/sec^2) $130=231.000 (X-axis maximum travel, millimeters) $131=85.000 (Y-axis maximum travel, millimeters) $132=16.000 (Z-axis maximum travel, millimeters) ok