Differences

This shows you the differences between two versions of the page.

--- gravograph [2018/04/30 21:09] – 5.56.201.162
+++ gravograph [2021/10/31 10:42] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+====== GravoGraph ======
+axis CNC Milling Engraving Mashine
+X:230mm Y:84mm Z:15mm
+XY: 1500mm/min
+Z:300mm/min
+VacuumTable 120mmx200mm
+VacuumCompressor: 100mbar(-0,9bar) 100%ED
+Firmware:GRBL 1.1
+Chip: m328p
+Driver: PololuLolo$random
+Interface: RaspBerryPi3B running CNCjs
+> GRBL 1.1 config:
+$$
+$0=10 (Step pulse time, microseconds)
+$1=25 (Step idle delay, milliseconds)
+$2=0 (Step pulse invert, mask)
+$3=4 (Step direction invert, mask)
+$4=0 (Invert step enable pin, boolean)
+$5=0 (Invert limit pins, boolean)
+$6=0 (Invert probe pin, boolean)
+$10=1 (Status report options, mask)
+$11=0.010 (Junction deviation, millimeters)
+$12=0.002 (Arc tolerance, millimeters)
+$13=0 (Report in inches, boolean)
+$20=1 (Soft limits enable, boolean)
+$21=1 (Hard limits enable, boolean)
+$22=1 (Homing cycle enable, boolean)
+$23=1 (Homing direction invert, mask)
+$24=500.000 (Homing locate feed rate, mm/min)
+$25=1500.000 (Homing search seek rate, mm/min)
+$26=250 (Homing switch debounce delay, milliseconds)
+$27=0.800 (Homing switch pull-off distance, millimeters)
+$30=1000 (Maximum spindle speed, RPM)
+$31=0 (Minimum spindle speed, RPM)
+$32=0 (Laser-mode enable, boolean)
+$100=629.851 (X-axis travel resolution, step/mm)
+$101=633.000 (Y-axis travel resolution, step/mm)
+$102=633.000 (Z-axis travel resolution, step/mm)
+$110=1500.000 (X-axis maximum rate, mm/min)
+$111=1500.000 (Y-axis maximum rate, mm/min)
+$112=1500.000 (Z-axis maximum rate, mm/min)
+$120=40.000 (X-axis acceleration, mm/sec^2)
+$121=40.000 (Y-axis acceleration, mm/sec^2)
+$122=40.000 (Z-axis acceleration, mm/sec^2)
+$130=231.000 (X-axis maximum travel, millimeters)
+$131=85.000 (Y-axis maximum travel, millimeters)
+$132=16.000 (Z-axis maximum travel, millimeters)
+ok